[. . . ] Therefore always follow these instructions to ensure correct and safe installation and functioning of the fitting and keep it for future reference. Always isolate the power before commencing installation, maintenance or repair. [. . . ] 18- Immediately replace a cracked or broken safety glass and use only manufacturer approved parts. The earth wire (yellow/green) has to be connected to the clip marked with . 20- Protection class II: the fitting is double insulated and must not be connected to an Earth. 21- Protection class III: the fitting is only suitable for very low voltage supply (e. W: only use lamps suitable for this fitting and keep within the maximum specified wattage. 33- Only use an incandescent globe bulb that is the size of the indicated diameter. 36- The fitting is only suitable for a lamp with built-in safety or a low pressure lamp. If the fitting is out of order after the bulb has been replaced, the internal fuse has to be replaced. If contact with the internal wiring can be made during this operation, this should be done by a competent electrician. 39- The fitting can be used in combination with a dimmer with exception where PLCE-lamps are used. consult a qualified electrician for choosing the right type (especially important for 12V-fittings). Replace a broken transformer only with a transformer with identical technical specifications. [. . . ] The manufacturer does not accept any liability for damage caused as a result of misuse or wrong application of the fitting. OBS: Nedanför finner Ni förklaringarna till alla figurer med hänvisning till de figurer som finns på framsidan av dessa säkerhetsinstruktioner: 01- Denna armatur är endast för inomhusbruk 02- Armaturen är inte lämplig att monteras i badrum (inte inom de specificerade zonerna). [. . . ]